I've read Chris Barley's (UK) wing notes and anything else I can find generally on the subject but still have questions so here is a list below, please feel free to give any other advice also. I'm starting on assembly of the centre section to ease me into the procedure and have machined up wood bearers to build onto so keeping the ribs away from the bench.
Has anyone not used a centre section cutout, how impractical would it be to not use a cutout, I am pretty slim if it helps?
Lastly I cannot find the technical drawings for mods on the website, can someone give me a link to them please?
Best wishes to you all,
Do I varnish everything before or after assembly and what about the inside of the leading edge wrap.
I'm going to use the top and bottom gusset plate method to secure the trailing edge, do I just feather in the top of the plates once the trailing edge is secured.
What is the best method for fitting the leading edge, screw and glue or just screw.
How do I square up the wing panels, they are too long to trammel I presume.
I'm sitting the spars on machined wood sections on the jig bench (chord wise), is this sufficient to ensure the wings will be level.