Foam Brushes.....

Discussion area for builders of Pietenpol aircraft, both beginners and experienced folks. Share ideas, ask questions and help build the Pietenpol community.
Post Reply
r1200gsDave
Posts: 65
Joined: Thu Nov 30, 2017 12:14 pm
Location: Monroe, WI USA
Contact:

Foam Brushes.....

Post by r1200gsDave »

So I am applying the EkoFill (Stewart System) primer to the tail feathers and the foam brushes are leaving behind some debris that is not helpful.

Anyone have a recommendation on a high quality foam brush. I know this is an oxymoron.... Good disposable foam brush....

Have a great week everyone!
Brian Amato
Posts: 112
Joined: Fri Aug 31, 2018 9:23 am

Re: Foam Brushes.....

Post by Brian Amato »

Yup. Doesn't seem to matter if you buy them at the dollar store or a paint store...all the same to me.
I had that happen to me when I was building the Corben. In the end, after it had dried well, I just used maroon Scotchbright pads and it knocked them right off and I was good to go.
r1200gsDave
Posts: 65
Joined: Thu Nov 30, 2017 12:14 pm
Location: Monroe, WI USA
Contact:

Re: Foam Brushes.....

Post by r1200gsDave »

that is what I suspected. thanks for the input.
Post Reply