Page 1 of 1
Tail dimensions on plans
Posted: Mon Mar 30, 2020 7:19 pm
by PoconoJohn
Are the dimensions shown on page 2 correct (for leading edge, main beam, etc)?
Thank you,
John C
Re: Tail dimensions on plans
Posted: Tue Mar 31, 2020 5:08 pm
by KenBickers
John,
Those are the dimensions that I used. It all begins to make sense when you start assembly the pieces. You end up with a bit of contour to the horizontal stabilizer.
The handwritten 3/16" on the main beam is not quite right. Each of the sides of the main beam should be routed down 3/32" per side.
Cheers, Ken
Re: Tail dimensions on plans
Posted: Tue Mar 31, 2020 6:08 pm
by PoconoJohn
Thanks Ken. I thought it was 3/16" because the 1" thickness minus the 5/8" in the center leaves 3/8"....or 3/16" on top and bottom. 3/16" also seemed right since the several stringers are 3/16" and fits on the ledge (but makes no sense on the leading edge). Hmmm. I have the whole thing laid out with everything just waiting for the epoxy. I'll keep looking at it.
Re: Tail dimensions on plans
Posted: Tue Mar 31, 2020 9:57 pm
by KenBickers
John,
Your 3/16" is correct. Blame it on a senior moment or just a wrinkle in the math multiplication universe. Are those the same thing, anyway? Yes, if you route out 3/16" from each side of the T-beam you will have removed a total of 3/8". That will give you a T that is 5/8" on the base of the T.
Sorry for causing confusion.
Cheers, Ken
Re: Tail dimensions on plans
Posted: Wed Apr 01, 2020 10:32 am
by PoconoJohn
Ha Ha. Thanks Ken. Keeps me on my toes.