Brodhead Pietenpol Association

Continental tapered shaft prop hub. Overall good. Does have minor pitting on one side. Threads in nut are good. Keyway nice. There is no plating, it is bare metal. Sold as is. Buyer to determine airworthiness. $150.00 plus shipping.
rob@stoinoff.com

Brand new set of mechanical drum brakes. Was going to use on Pietenpol. Centers drilled out for 1.5 axle.
$ 75.00 plus shipping email rob@stoinoff.com
Thanks

I twisted just my ends a little for better alignment. Not the whole horn.

Thanks Oscar

Brace wires are hard wires. Also all wrapped and soldered cable ends. Everything period correct as possible.

Lol…I was wondering….

It’s the steel fuselage per original drawings. Model A Ford.

With cover on.

Not sure why pictures are upside down but right side up if you click on them.

Made supports for front and rear attached to spars and floor. Center supports added. Fuel tank sits on those supports. Fuel tank made to largest size possible, and is a tight press fit with felt around edges. Top cover over top of tank holds tank down. No need for any straps or drilling holes in spa...

Thanks Oscar

Thanks Richard, it’s getting closer. Wings, ailerons, center section, and all tail feathers are finished. Down to finishing fuselage.

I did mine the same way. Felt under around around tank for tight fit. Felt on top with cover holding everything in.

Sorry, Sold

Yes Richard, it is 3/8 long by 1/4 thick.

Thanks Oscar

Richard, Here are some pictures of my trailing edge. I didn't want any lumps in the fabric with gussets and wanted a smooth transition. Made tongue and grove. Made a jig to hold my ribs and cut slots on router after the ribs were completed. I made a pattern of what I wanted for trailing edge and too...

SOLD !

I have 2, Moto Meter Oil pressure gauges. $30.00 each plus shipping or can bring to Brodhead.
Thanks Rob
812-932-9000
rob@stoinoff.com

A set of Ken Perkins spoke wheel hubs, 40 spokes, and the hub spacers for brakes. $150.00 plus shipping, or can bring to Brodhead.

Thanks Rob
812-932-9000
rob@stoinoff.com

I have had several sets of windshields made. $125.00 a pair for a front and rear, plus shipping cost. Or can bring to Brodhead. Selling in pairs only. Rear windshield is a little taller than front. These are the same size as the ones Ken Perkins was selling. Tried buying a set from him but he could ...

Thanks Douwe, yours looks good on the Lee Bottom calendar! Have it hanging in my office.

Thanks Clay, my father is working on the MNF. Everything is covered minus the fuselage. Hopefully it will fly in the next few years. Will try to find time to update website with current pictures soon. Check back...

Guess I'll make the first post on progress of my project. Model A engine ready to go. Diamond block, Scat counterweight crank, Insert bearings, Scat rods, custom made Ross Pistons, Model B cam, bigger valves, pressurized oil system, Dan Price dual plug head drilled for aviation plugs, dual Slick mag...