=?utf-8?Q?RE:_Pietenpol-List:_fly-ins?

An archive of the Matronics Pietenpol Listserve.
Locked
matronics
Posts: 81779
Joined: Sat Mar 18, 2017 8:29 am

=?utf-8?Q?RE:_Pietenpol-List:_fly-ins?

Post by matronics »

Original Posted By: "=?utf-8?Q?aviatorbell(at)yahoo.com?="
Hi JohnI just checked my plans, and, as bill stated, the lower drawing has the dimensionsto be concerned about- follow that oneThe upper drawing is there so you can plot the points to draw the airfoil if youdon't have the full-size drawing.As far as the horizontal main beam- the 5/8" is right- anything that winds up sticking above the surface will be sanded down flush later.--------Earl BrownI may not have gone where I intended to go, but I think I have ended up where Iintended to be.Read this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: =?utf-8?Q?RE:_Pietenpol-List:_fly-ins?
Locked