Pietenpol-List: Re: Piet Stuff -Reply
Posted: Fri Oct 03, 1997 3:37 pm
Original Posted By: jay@hsmpk12a-s2.Eng.Sun.COM (Janine Sunlin [TEMP])
I boxed each end of the axle where it sticks through the wooden gear oneach side; in other words, I squared up the axle by welding plates to thesides. Then I made a verticle slot for them to slide in. This stops rotationand also limits verticle travel to about 3-4 inches. I haven't flow it yet, butknow it will work. Saw similar setups at Broadhead. Bill________________________________________________________________________________
I boxed each end of the axle where it sticks through the wooden gear oneach side; in other words, I squared up the axle by welding plates to thesides. Then I made a verticle slot for them to slide in. This stops rotationand also limits verticle travel to about 3-4 inches. I haven't flow it yet, butknow it will work. Saw similar setups at Broadhead. Bill________________________________________________________________________________