Page 1 of 1
Pietenpol-List: Re: My question about Ford Model A
Posted: Wed Nov 19, 1997 10:28 am
by matronics
Original Posted By:
jay@hsmpk12a-s2.Eng.Sun.COM (Janine Sunlin [TEMP])
________________________________________________________________________________
Pietenpol-List: Re: My question about Ford Model A
Posted: Wed Nov 19, 1997 11:02 am
by matronics
Original Posted By: "McNarry, John"
Yesterday I asked about the standard bore sizes, etc. for the model A engine belonging to our Pietenpol. I haven't heard back anything, so... does anyone know where such information can be obtained? There doesn't seem to be any specifications anywhere on the Web.Thanks again,J. Sunlin________________________________________________________________________________
Pietenpol-List: RE: My question about Ford Model A
Posted: Wed Nov 19, 1997 12:00 pm
by matronics
Original Posted By: "McNarry, John"
I have a friend who collects cars. He has a few Model As, I'll ask himif he knows.Carl J. HixonProject Engineer_______________________Dura Pharmaceuticals, San Diego, CA 92121Phone: (619) 784-6747 Fax: (619) 453-2544Web Page:
http://www.durapharm.com On Wednesday, November 19, 1997 9:03 AM,
jay@hsmpk12a-s2.Eng.Sun.COM[SMTP:
jay@hsmpk12a-s2.Eng.Sun.COM] wrote:> Yesterday I asked about the standard bore sizes, etc. for the model Aengine > belonging to our Pietenpol. I haven't heard back anything, so... doesanyone > know where such information can be obtained? There doesn't seem to beany > specifications anywhere on the Web.> > Thanks again,> > J. Sunlin________________________________________________________________________________
Pietenpol-List: Re: My question about Ford Model A
Posted: Wed Nov 19, 1997 12:01 pm
by matronics
Original Posted By:
jay@hsmpk12a-s2.Eng.Sun.COM (Janine Sunlin [TEMP])
________________________________________________________________________________
Pietenpol-List: Re: My question about Ford Model A
Posted: Wed Nov 26, 1997 7:16 pm
by matronics
Original Posted By: PHIL PECK
>Yesterday I asked about the standard bore sizes, etc. for the model A engine >belonging to our Pietenpol. I haven't heard back anything, so... does anyone >know where such information can be obtained? There doesn't seem to be any >specifications anywhere on the Web.>>Thanks again,>>J. Sunlin>some years ago I bought a book for rebuilding the model A (all the carincluding the engine) from J.C. Whitney & Co. Ask them they have a WebPage....(?)SaludosGary Gower________________________________________________________________________________