Pietenpol-List: NA-S3 B Stromber Carburetor

An archive of the Matronics Pietenpol Listserve.
Locked
matronics
Posts: 81779
Joined: Sat Mar 18, 2017 8:29 am

Pietenpol-List: NA-S3 B Stromber Carburetor

Post by matronics »

Original Posted By: "vagabondpa15"
Last night I began making my cabane fittings for the center section. After readinghow to bend the u-shaped material and the minimum radius needed, I proceededto make a fitting. With this u-shaped piece fitting over the spar, I havea good gap in the wood to metal area because of the radiused metal and sharpededged wood. Do most of you sand the wood in that area to fit the radius ofthe metal?--------JohnRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: NA-S3 B Stromber Carburetor
matronics
Posts: 81779
Joined: Sat Mar 18, 2017 8:29 am

Pietenpol-List: Re: NA-S3 B Stromber Carburetor

Post by matronics »

Original Posted By: "vagabondpa15"
My next question is where do you measure the float dem. 13/32 ?I understand you start at the parting line of the float bowel but down to what?Also do you include the thickness of the gasket?I want to thank all who responded to my first questions.Thank you all again.Dave H--------Dave HarmonRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: NA-S3 B Stromber Carburetor
matronics
Posts: 81779
Joined: Sat Mar 18, 2017 8:29 am

Post by matronics »

Original Posted By: Michael Perez
OK I think I got it! down to the fuel level. This level is determined by the pressureof the fuel just like it is in the aeroplane. Head pressure inches WC orpsi etc..... so I simulate it with gas line & funnel.Dave H--------Dave HarmonRead this topic online here:http://forums.matronics.com/viewtopic.p ... ______Date: Tue, 12 Apr 2011 08:10:10 -0700 (PDT)
matronics
Posts: 81779
Joined: Sat Mar 18, 2017 8:29 am

> Pietenpol-List: Re: Speaking of Wing Sweep and CG

Post by matronics »

Original Posted By: shad bell
> --> Pietenpol-List message posted> by: "Pieti Lowell" > > Mike,> What lengths are your Cabanes ? > Pieti Lowell> > > > > Read this topic online here:> > http://forums.matronics.com/viewtopic.p ... 676#336676> > > > > > > > Email Forum -> FAQ,> - MATRONICS WEB FORUMS -> List Contribution Web Site -> -Matt> Dralle, List Admin.> > > > ________________________________________________________________________________Date: Tue, 12 Apr 2011 09:52:48 -0700 (PDT)
Locked