Brodhead Pietenpol Association

Posted: **Tue Mar 24, 2015 10:21 am**

Original Posted By: Fastnaught John
Malcolm,Good input. Would love to see photos. As you have done, I shortened each outboard panel to make up for the wider center-section- so my wingspan will remain essentially the same.--------Jake Schultz - curator,Newport Way Air Museum (OK, it's just my home)Read this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Need some contact info

Posted: **Tue Mar 24, 2015 12:24 pm**

Original Posted By: "tkreiner"
25% off!http://www.eaa.org/en/eaa-shop/media/av ... s-set-of-4 Sent from my iPadJack Textor________________________________________________________________________________Subject: Pietenpol-List: Re: Need some contact info

Posted: **Tue Mar 24, 2015 2:08 pm**

Original Posted By: "dgaldrich"
Try calling Mike Weeden at 608-214-6652, he'll know the phone number for Dick...--------Tom KreinerRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: Metal Fittings

Posted: **Tue Mar 24, 2015 3:49 pm**

Original Posted By: gliderx5(at)comcast.net
Didn't Ken Perkins offer some or all of the metal bits? There's also a synapsefiring that says he had them in a CAD program so they could be done on a waterjet/laserjetmachine. I know he's bowing out of the Model A Ford business buthe might still have the code available for the flat metal bits. If he has,in fact, bowed out of all things aviation, it's our loss.Read this topic online here:http://forums.matronics.com/viewtopic.p ... ______Date: Wed, 25 Mar 2015 01:22:07 +0000 (UTC)