Pietenpol-List: Re: prop carving...

matronics · Post by **matronics** » Thu May 27, 1999 9:50 am

Original Posted By: John Greenlee
As Steve writes I have carved a few. I am building the prop duplicator for this next one just to see if it is any quicker.Duane NX6398________________________________________________________________________________

matronics · Post by **matronics** » Sat May 29, 1999 10:47 pm

Original Posted By: Eric Norris
I will be sure and take a few step by step shots this time through so that I can send them to whoever is interested.Duane NX6398________________________________________________________________________________