Original Posted By: Alan Swanson
Subject: Pietenpol-List: Machining Work Needed...Listers,I am currently in need of some aluminum machining work that involvesmilling the faceplate for the FuelScan instrument manufactured byMatronics. I have done this work in-house on our own CNC vertical millin the past and this has proved cost affective and allowed for thefine tuning of the design. I am now in need of a rather large lot of units and would like to farm the work out if I can obtain a reasonable cost point.I have compiled a detailed set of files that include a DXF drawing ofthe faceplate, the GCodes that I have used to create the piece, a numberof very clear photos of the finished unit, and a text file of generalnotes on milling the faceplate. These are contained within the Zip file below: http://www.matronics.com/fuelscan/faceplate.zipIf you have the necessary CNC capability and would be interested quoting on the job, please contact me via email at the following address: dralle(at)matronics.comI will provide you with quantities and needed delivery schedule.Thank you for your assistance.Matt DralleMatronicsEmail List Admin.RV-4 Builder-- Matt G. Dralle | Matronics | P.O. Box 347 | Livermore | CA | 94551925-606-1001 Voice | 925-606-6281 FAX | dralle(at)matronics.com Emailhttp://www.matronics.com/ W.W.W. | Featuring Products For Aircraft________________________________________________________________________________Date: Sun, 27 Feb 2000 17:31:16 -0600