Original Posted By: "Joe Krzes"
Carl,Very interesting problem there with widening the hub. I recall that BPA (Buckeye Pietenpol Association) had a few newsletters on this in which they basically had the center hub machined to accept the desired axle diameter and the O.D. of each end was turned to provide a shoulder so that a disk, which was drilled to accept the spokes, would self locate on the hub and then be welded in place.I had kept this information in a binder which seems to have fell intoone of the many Black Holes around my place. I'll have to reallysearch in the round abouts there of and find it, this is too importantof material to let get away from me. I'll get back to you.RodgerPiet in progress________________________________________________________________________________