Pietenpol-List: Kyle's center section cargo area cover

[matronics]

Original Posted By: "C N Campbell"
Subject: Pietenpol-List: Kyle's center section cargo area coverVery nicely fabricated Kyle. It appears as though your workmanship is reallytop notch. I'm very impressed at how the standard of Pietenpol craftsmanshiphas continually gotten better over the past ten years or so. Outstanding workgoing on out there in little shops, garages, and basements around this landand far off lands.Beauuutiful work.Mike C.________________________________________________________________________________

[matronics]

Original Posted By: Cuy, Michael D. (GRC-RXD0)[ASRC AEROSPACE CORP]
Michael, thanks for the reply. I was going to ask Kyle but I'll ask you instead, what thickness aluminum sheet did you use? I was thinkiing of ordering enough to do both the cover and the cowling around my Corvair engine as well as the cowls on the fuselage. I have Hans Van DerVoort's drawings for his engine cowl, but he doesn't stipulate the thickness of the material. Chuck ----- Original Message -----

[matronics]

Original Posted By: "Bill Church"
Subject: Pietenpol-List: Aluminum thickness: Kyle's center section cargo areacoverChuck- I used .025" 2024T3 for everything sheet aluminum wiseon my Pietenpol including the center section cargo cover lid. Mike C.________________________________________________________________________________Subject: Pietenpol-List: Re: Kyle's center section cargo area cover