Original Posted By: Hans van der Voort
Subject: Pietenpol-List: Another Turnbuckle QuestionYes another! Thanks to all for the interesting data on the last question. Is therea barrel between 3/16 and 1/4? I have a bunch of short barrels that seemto be between 3/16 and 1/4 that measure 7/32. I can't find any listings for thisin any of the vendor catalogs.Thanks again!Jack TextorSent from my iPad________________________________________________________________________________Date: Fri, 14 Oct 2016 01:18:48 +0000 (UTC)
Pietenpol-List: Another Turnbuckle Question
Pietenpol-List: Re: Another Turnbuckle Question
Original Posted By: "Bill Church"
I agree, Ray. Very impressive collection of highly technical data and analysis.And the two authors were former faculty members at MIT department of Aeronautics.I'm surprised that there even was a department of Aeronautics only 15 yearsafter the first powered flight.Lots of interesting stuff in the book, aside from the turnbuckle information.Bill C.Read this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: Another Turnbuckle Question
I agree, Ray. Very impressive collection of highly technical data and analysis.And the two authors were former faculty members at MIT department of Aeronautics.I'm surprised that there even was a department of Aeronautics only 15 yearsafter the first powered flight.Lots of interesting stuff in the book, aside from the turnbuckle information.Bill C.Read this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: Another Turnbuckle Question
Original Posted By: Jack Textor
Jack,Where is this measurement being taken?Bill C.Read this topic online here:http://forums.matronics.com/viewtopic.p ... __________
Jack,Where is this measurement being taken?Bill C.Read this topic online here:http://forums.matronics.com/viewtopic.p ... __________