Original Posted By: "Brent Wilson"
Whatever the case as far as formalities and logbook entries for the purpose onworking on a rating, I would consider stick time in an Air Camper to be both valuableand pleasurable to anyone who is learning to fly or looking to improvetheir stick and rudder skills. The fact that flight time in a Piet is very,very inexpensive makes it all the more fun. When I flip on the master switchon a $120/hr certified rental airplane, every minute that the gyros are whirringI can feel two bucks leaving my pocket. Those same two bucks can buy me enoughavgas to fly a touch-and-go in the Piet. I can go out and put 2.0 hr inthe logbook in the Piet and burn less than $40 on gas and oil for a very niceafternoon flight but I will burn that in rental cost just with ground operationsin the certified rental aircraft. Just sayin'.--------Oscar ZunigaMedford, ORAir Camper NX41CC "Scout"A75 power, 72x36 Culver propRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Archives?
Pietenpol-List: Archives?
Pietenpol-List: Re: Archives?
Original Posted By: "taildrags"
John; when I had to rebuild the front seat in 41CC, I added vertical sticks tosupport the aft ends of the seat side rails. It's not fancy, but I just feltlike with passengers stepping into the front cockpit and standing on the seat,it needed vertical support. Some pictures here (but Peter's are WAAYY nicer!):http://www.flysquirrel.net/piets/repair ... -----Oscar ZunigaMedford, ORAir Camper NX41CC "Scout"A75 power, 72x36 Culver propRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: Archives?
John; when I had to rebuild the front seat in 41CC, I added vertical sticks tosupport the aft ends of the seat side rails. It's not fancy, but I just feltlike with passengers stepping into the front cockpit and standing on the seat,it needed vertical support. Some pictures here (but Peter's are WAAYY nicer!):http://www.flysquirrel.net/piets/repair ... -----Oscar ZunigaMedford, ORAir Camper NX41CC "Scout"A75 power, 72x36 Culver propRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: Archives?
Pietenpol-List: Re: Archives?
Original Posted By: "Brent Wilson"
Brent: go here-http://www.matronics.com/search/Start by selecting the Pietenpol list, then enter your search word(s) and any othercriteria, and there you go. For example, I just searched on the word 'mockup'and got 154 messages in 1 second of searching.--------Oscar ZunigaMedford, ORAir Camper NX41CC "Scout"A75 power, 72x36 Culver propRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: Archives?
Brent: go here-http://www.matronics.com/search/Start by selecting the Pietenpol list, then enter your search word(s) and any othercriteria, and there you go. For example, I just searched on the word 'mockup'and got 154 messages in 1 second of searching.--------Oscar ZunigaMedford, ORAir Camper NX41CC "Scout"A75 power, 72x36 Culver propRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: Archives?