Original Posted By: "aerocarjake"
Having trouble viewing this email? Click Here.Snowflake Gifts for All AgesSnowflake Party Crackers$20.00$18.00 (members)* SAVE 15% on this item with Promotion Code DECOR15 *Snowflake Soaps$40.00$36.00 (members)* SAVE 15% on this item with Promotion Code DECOR15 *Crystal Snowflake Pin$45.00$40.50 (members)Snowflake Bentley$17.00$15.30 (members)To place a phone order or request a Catalog call 1-866-945-6897. Please reference source code H2IE9811.This is a promotional message from SmithsonianStore.comPlease send your comments to SmithsonianStore(at)si.edu To change your address or unsubscribe, click here.If you would like to change your email preferences, click here. SmithsonianStore.com600 Maryland Avenue, SW, Suite 6001 Washington, DC 20024 Read our Privacy Policy here. =A92011 Smithsonian Institution. All rights reserved.________________________________________________________________________________Subject: Pietenpol-List: ROTEC updated my project page...
Pietenpol-List: ROTEC updated my project page...
Pietenpol-List: Re: Bending 5052 Fuel Tank
Original Posted By: "carson"
http://www.rotecengines.com/Projects/Ja ... .HTMLHello everyone..... ROTEC updated my project page on their website with photos I sent in (thanks Jim.)Having a good time now that fall "building season" is back in swing.(Note: you may have to scroll down a bit to get to the October update section.)Enjoying reading about other Piet progress and flying on this Matronics site......!Jake--------Jake Schultz - curator,Newport Way Air Museum (OK, it's just my home)Read this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: Bending 5052 Fuel Tank
http://www.rotecengines.com/Projects/Ja ... .HTMLHello everyone..... ROTEC updated my project page on their website with photos I sent in (thanks Jim.)Having a good time now that fall "building season" is back in swing.(Note: you may have to scroll down a bit to get to the October update section.)Enjoying reading about other Piet progress and flying on this Matronics site......!Jake--------Jake Schultz - curator,Newport Way Air Museum (OK, it's just my home)Read this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: Bending 5052 Fuel Tank
Pietenpol-List: Re: ROTEC updated my project page...
Original Posted By: "aerocarjake"
Thanks for the replies I think that I will go with the rivetsThanksRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: ROTEC updated my project page...
Thanks for the replies I think that I will go with the rivetsThanksRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: ROTEC updated my project page...