Original Posted By: Rick Schreiber
I bought a brand new (old stock) slick 48-1 magneto that I think was for a Lycoming0290G engine. I want to use this mag on a Ford Model A engine, I do not haveany plug wires (Harness) can anyone tell me how to convert this mag to autoplug wires? Or should I just try and sell this mag?ThanksWalterRead this topic online here:http://forums.matronics.com/viewtopic.p ... ______Date: Sun, 19 Feb 2012 21:02:01 -0600
Pietenpol-List: Slick Magneto 48-1
Re: Pietenpol-List: Wing brace wires
Original Posted By: "Rick Schreiber"
The lift strut cables on NX18235 are 1/8" .Greg C----- Original Message -----
The lift strut cables on NX18235 are 1/8" .Greg C----- Original Message -----
Pietenpol-List: Slick Magneto 48-1
Original Posted By: "Overalles"
> > --> Pietenpol-List message posted> > by: "Clif Dawson" > > > Ha! Now we're talkin!
> > Needs wheel pants to complete the scheme though.> > > > Clif> > > > > > > Hey Clif,> > > > > > How about now?> > > (although technically, it's a GN-1, rather than a> > Piet)> > > > > > Bill C.> > > > > > Email Forum -> > ---- MATRONICS WEB FORUMS -> > List Contribution Web Site -> > - - - - - - - -Matt> > Dralle, List Admin.> > > > > > > > > > > > > le, List Admin.________________________________________________________________________________Subject: Pietenpol-List: Slick Magneto 48-1
> > --> Pietenpol-List message posted> > by: "Clif Dawson" > > > Ha! Now we're talkin!
> > Needs wheel pants to complete the scheme though.> > > > Clif> > > > > > > Hey Clif,> > > > > > How about now?> > > (although technically, it's a GN-1, rather than a> > Piet)> > > > > > Bill C.> > > > > > Email Forum -> > ---- MATRONICS WEB FORUMS -> > List Contribution Web Site -> > - - - - - - - -Matt> > Dralle, List Admin.> > > > > > > > > > > > > le, List Admin.________________________________________________________________________________Subject: Pietenpol-List: Slick Magneto 48-1