Pietenpol-List: Hardware Size

matronics · Post by **matronics** » Sun Jun 10, 2012 2:53 pm

Original Posted By: aircamperace(at)yahoo.com
Fantastic Bob!!!!....And you have a really nice looking aeroplane!!!Read this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Hardware Size

matronics · Post by **matronics** » Sun Jun 10, 2012 6:26 pm

Original Posted By: "Gary Boothe"
Can anyone please share with me what size hardware they used on the forward rudderpedal brackets and control stick bearing mounts? I've searched the archivesand looked over the drawings with no luck. AN3s seem way too thick for the copilotsrudder pedals considering they are only going thru plywood.Thanks,RyanSent from my iPhoneOn Jun 10, 2012, at 3:53 PM, "moondogman" wrote:> > Fantastic Bob!!!!....And you have a really nice looking aeroplane!!!> > > > > Read this topic online here:> > http://forums.matronics.com/viewtopic.p ... 220#375220> > > > > > > > > > ________________________________________________________________________________

matronics · Post by **matronics** » Sun Jun 10, 2012 8:06 pm

Original Posted By: owner-pietenpol-list-server(at)matronics.com
AN3's, but with AN970 washers (large).Gary BootheNX308MB-----Original Message-----

matronics · Post by **matronics** » Sun Jun 10, 2012 8:43 pm

Original Posted By: Jim Boyer

matronics · Post by **matronics** » Mon Jun 11, 2012 4:37 am

Original Posted By: owner-pietenpol-list-server(at)matronics.com
I used AN3's, with AN 970 washers under the nuts.Jack PhillipsNX899JPSmith Mountain Lake, Virginia-----Original Message-----

Brodhead Pietenpol Association