Page 1 of 1
status of current build
Posted: Thu Feb 11, 2021 3:38 pm
by doug bryant
adding pics of current build. this will be cont powered, long fuse, cowings are also complete.
Re: status of current build
Posted: Fri Feb 12, 2021 7:06 pm
by doug bryant
cont engine mount tac weld fixture.
Re: status of current build
Posted: Sat Feb 13, 2021 9:52 am
by danoliver
It looks like you and I are at about the same stage. Where are you located? I'm in Cincinnati Ohio. Would be cool to get together.
Re: status of current build
Posted: Sat Feb 13, 2021 10:22 am
by doug bryant
im in wichita, ks. do u have pics?
Re: status of current build
Posted: Sat Feb 13, 2021 4:19 pm
by danoliver
I do.
Here’s a few.
Re: status of current build
Posted: Sat Feb 13, 2021 7:56 pm
by doug bryant
very nice work!! can't wait to see it flying. this one i am building is my 7th. i still need to build some of the tail feathers.
Re: status of current build
Posted: Sat Feb 13, 2021 8:03 pm
by tom kreiner
Dan,
Beautiful work, and beautiful work,a ship!
What is the angled blue steel strap at the rear end of the plywood on the S’board side of the fuselage?
Re: status of current build
Posted: Mon Feb 15, 2021 5:44 am
by danoliver
SEVENTH BUILD!
At some point I think you can no longer call it amateur built ha ha.
Could we get a photo montage of your life's work?
Tom, the blue fitting is just a U shaped strap for attaching a seat belt to.
Also, I was asked in a PM about the cable clamps on the center section cross bracing. These are temporary hardware store clamps, the airworthy versions will be swaged.
Re: status of current build
Posted: Wed Feb 24, 2021 9:13 am
by doug bryant
fuel tank complete and ready for filler neck. tank has stesrman type fuel gage.
Re: status of current build
Posted: Wed Feb 24, 2021 10:12 am
by taildrags
Which epoxy resin did you use on the fuel tank? Do you plan to run auto gas?
Oscar Zuniga
Medford, OR
Air Camper NX41CC, A75 power, avgas
Re: status of current build
Posted: Wed Feb 24, 2021 10:51 am
by doug bryant
polyester resin; non-alcohol fuels. i have built a few tanks like this with great results.
Re: status of current build
Posted: Wed Feb 24, 2021 3:44 pm
by taildrags
OK. It's the alcohol blended autofuels that can cause problems. Sounds like you're all over it!
-Oscar
Re: status of current build
Posted: Thu Feb 25, 2021 10:08 am
by doug bryant
used top from a dried can of pvc glue for filler neck and cap. plywood template is the master tool for all the top division work
Re: status of current build
Posted: Thu Feb 25, 2021 10:58 am
by doug bryant
the loop is where the small chain will be attached.
Re: status of current build
Posted: Sun Mar 14, 2021 7:30 pm
by doug bryant
these are the hardest parts to make on the entire airplane; but got them done
Re: status of current build
Posted: Mon Mar 15, 2021 7:16 pm
by jdoucet
These are beautiful builds. It's almost a shame that we have to cover them to make them fly.
Re: status of current build
Posted: Tue Mar 16, 2021 3:33 pm
by doug bryant
that is very true
Re: status of current build
Posted: Sun Mar 21, 2021 5:58 pm
by doug bryant
completed tail feather fitting and rigging today. it was a productive day.
Re: status of current build
Posted: Sun Mar 28, 2021 6:40 pm
by doug bryant
started covering today
Re: status of current build
Posted: Sun Mar 28, 2021 11:28 pm
by KenBickers
Congratulations!! It's a great feeling to be at the covering stage. Suddenly the light at the end of the tunnel seems much brighter.
Cheers, Ken
Re: status of current build
Posted: Mon Mar 29, 2021 6:31 pm
by doug bryant
all true! its a fun build!
Re: status of current build
Posted: Thu Apr 08, 2021 7:46 pm
by doug bryant
continuing to cover; tail feathers are almost done.
Re: status of current build
Posted: Thu Apr 08, 2021 10:50 pm
by taildrags
Careful... I see you've got that plane inverted. Note that the Air Camper is Normal category and only good for negative 1.52 G ;o)
-Oscar Z.
Re: status of current build
Posted: Fri Apr 09, 2021 8:41 am
by doug bryant
sure is easier to cover the bottom upside down though
Re: status of current build
Posted: Fri Apr 16, 2021 4:54 pm
by doug bryant
continuing covering, fuse, tail feathers,
Re: status of current build
Posted: Mon Apr 19, 2021 8:55 pm
by doug bryant
Re: status of current build
Posted: Mon Apr 26, 2021 9:18 am
by PoconoJohn
danoliver wrote: ↑Sat Feb 13, 2021 4:19 pm
I do.
Here’s a few.
Oh gosh Danoliver! That's beautiful! Don't ever cover it!
John C
Re: status of current build
Posted: Wed May 05, 2021 8:41 pm
by doug bryant
making small amounts of progress every day.
Re: status of current build
Posted: Fri May 07, 2021 8:21 am
by doug bryant
installing tail group next
Re: status of current build
Posted: Fri May 07, 2021 7:23 pm
by Richard Roller
Nice!
Re: status of current build
Posted: Thu May 20, 2021 7:49 pm
by doug bryant
more progress
Re: status of current build
Posted: Tue May 25, 2021 5:46 pm
by Piper
doug bryant wrote: ↑Sat Feb 13, 2021 7:56 pm
very nice work!! can't wait to see it flying. this one i am building is my 7th. i still need to build some of the tail feathers.
I think one of my former employers bought avionics from the same place you did! (The local photocopy-shop.)
Re: status of current build
Posted: Tue Jun 15, 2021 9:44 pm
by doug bryant
engine instl started.
Re: status of current build
Posted: Sun Aug 22, 2021 6:02 pm
by doug bryant
completed more on engine, covered ailerons, wing ready for cover.